How to adjust cmc manual jack plate

CMC Manual Jack Plates. $ Please Select One. ML Manual Jack Plate 5 1/2" setback Two Piece Manual Jack Plate 4" setback Two Piece Manual Jack Plate 5 1/2" setback ML Manual Jack Plate, 10" setback MLHD Heavy Duty Manual Unit for Hp V8s and Smaller /2”" Set Back - Manual Model one piece, 2” of vertical 5/5(3). motor. To adjust the manual Power-Lift simply loosen the 4 clamp bolts on the sides using a /8” wrench. Using the same wrench, turn the 3/4” nut at the top or the bottom of the Power-Lift to raise or lower the motor (See arrows Fig. 34). Then tighten the 4 clamp bolts to hold it in position. The clamp bolts on all of our manual. To adjust appropriately, follow these steps: Using a pencil, mark the current height of the jack plate for reference. To accurately determine the height of the engine and therefore where the jack plate supports your motor before adjusting, make sure your boat is level and measure the distance from the pad to the floor, and then from the center Missing: cmc.

CMC Manual Jack Plates. $ Please Select One. ML Manual Jack Plate 5 1/2" setback Two Piece Manual Jack Plate 4" setback Two Piece Manual Jack Plate 5 1/2" setback ML Manual Jack Plate, 10" setback MLHD Heavy Duty Manual Unit for Hp V8s and Smaller /2”" Set Back - Manual Model one piece, 2” of vertical adjustment. Quantity.5/5(3). motor. To adjust the manual Power-Lift simply loosen the 4 clamp bolts on the sides using a /8” wrench. Using the same wrench, turn the 3/4” nut at the top or the bottom of the Power-Lift to raise or lower the motor (See arrows Fig. 34). Then tighten the 4 clamp bolts to hold it in position. The clamp bolts on all of our manual. Place a board or some other sturdy base below the jack plate. Place the car jack on the base and, using a sturdy length of wood, approximately 2 feet in length, raise the wood on the car jack until it is flush with the bottom of the engine. Now, loosen the bolts on either side of the jack plate, and raise or lower the engine to its new height.

One Piece Manual Features: Made of T6 extruded aluminum alloy; Stainless steel fasteners for maximum strength and durability; Centrally located adjustment. Transom jacks are used to adjust the motor higher out of the water for optimal shallow water performance. This essentially provides less drag on the boat. The. A total of 8” of possible adjustment. It also can be purchased with stainless steel motor rails, Model PLSS (for V-8 motors HP MAX).